Rail transport ·

RID 2027 published: what changes for rail freight

On 19 November, OTIF published the consolidated 2027 edition of the Regulations concerning the International Carriage of Dangerous Goods by Rail (RID). Railway undertakings and their safety advisers have three dates to consider when planning the changeover.

Three dates for the changeover

  • 1 January 2027RID 2027 takes effect.
  • 30 June 2027Last day of the general transitional period for carrying goods under RID 2025, unless a specific provision applies (1.6.1.1).
  • 31 December 2027Last day for using instructions in writing that conform to the RID requirements applicable up to 31 December 2026 (1.6.1.58).

What changes in the instructions in writing

The model in 5.4.3.4 runs to four pages. The first (5-40) sets out the actions to take in an accident or incident. OTIF highlights changes in yellow on the following three pages. Select an image to read the original English page at full size.

Images from OTIF, RID 2027, 5.4.3.4. Yellow highlighting is reproduced from the original edition.

Open the complete four-page model in the OTIF PDF

Other changes affecting rail operations

Batteries installed in cargo transport units

Table A distinguishes lithium metal batteries (UN 3563) and sodium ion batteries (UN 3564) installed in cargo transport units. UN 3536 covers lithium ion batteries installed in these units. New provisions also address hybrid batteries combining lithium ion and sodium ion cells.

RID 2.2.9.1.7.1 (h) and special provisions 389 and 410

Used equipment and packagings containing residues

Paragraph 2.1.5.7 sets conditions for sending certain used equipment containing dangerous goods residues for repair, inspection, maintenance, disposal or recycling. Paragraph 4.1.1.11.2 covers certain empty, uncleaned drums and intermediate bulk containers (IBCs) over 150 litres carried for disposal, recycling or material recovery.

RID 2.1.5.7 · RID 4.1.1.11.2

Wagons and WE equipment codes

Where column 14 of Table A specifies a WE code, 7.1.2.2 identifies the equipment concerned and refers to the technical prescriptions for freight wagons (UTP WAG). Operators can use these references to check the equipment on the wagon assigned to a consignment.

RID 7.1.2.2

Training records and the transport document

Paragraph 1.3.3 clarifies who must retain training records. For waste in tanks, if the exact quantity cannot be measured at the place of loading, 5.4.1.1.3.2 allows an estimate subject to its conditions and exclusions. A device or procedure must ensure compliance with the prescribed degrees of filling.

RID 1.3.3 · RID 5.4.1.1.3.2

What to review in your undertaking

Identify the copies held in drivers’ cabs, set a replacement date and record the refresher training. The carrier must give the driver instructions in a language they can read and understand, and make sure they can carry them out (5.4.3.2).

Official sources